Trinity Highway QuadGuard M Wide, Product Description Assembly Manual

Page: 15 / 64

TrinityHighway.com 14 Revision D March 2021
Hammers

Sledgehammer

Standard hammer
Wrenches

Heavy duty 1/2” drive impact wrench

1/2" drive sockets: 7/16”, 9/16”, 15/16”, 1 1/16”, 1 1/8”, 1 1/4”

1/2" drive Deep well sockets: 15/16”, 1 1/4”

1/2" drive Ratchet and attachments

1/2" drive Breaker bar – 24” long

1/2" drive Torque wrench: 200 ft-lb

Combination wrench(s): 7/16”,9/16”, 15/16”, 1 1/8”

Hex Key (Allen) wrench: 3/8”
Important:
Trinity Highway makes no recommendation whether use or
reuse of any part of the system is appropriate or acceptable following an
impact. It is the sole responsibility of the project engineer and/or the local
highway authority and its engineers to make that determination. It is critical
that you inspect this product after assembly is complete to make certain that
the instructions provided in this manual have been strictly followed.
Miscellaneous

Traffic control equipment

Lifting and moving equipment (A lifting device is preferred although a forklift can be used.)
Minimum 5,000 lb. capacity required.

Air Compressor (100 psi minimum) and Generator (5 kW)

Long pry bar

Drift pin 12” [300 mm]

Center punch

Tape measure 25’ [7.5 m]

Chalk line

Concrete marking pencil

Steel bristled tube brush for cleaning 7/8” drilled boreholes

Rags, water, and solvent for touch-up
Note:
The provided list of tools is a general recommendation and should not be
considered an extensive list. Depending on specific site conditions and the complexity of
the assembly specified by the appropriate highway authority, the required tools may vary.
Decisions as to what tools are needed to perform the job are entirely the responsibility of
the specifying highway authority and the authority’s selected contractor performing the
assembly of the system at the authority’s specified assembly site.