Seeker D User’s Guide
Document Num., Rev. 4
May 2018
Page 60
Display Messages & Error Codes
Seeker D Error Codes
The codes shown below are displayed on the Seeker D display
screen as “E##” to indicate an error with the Seeker D.
“E##”
Code
Error Description
Solution
01
The checksum is not valid for this area
or the calibration date for this area is
not set.
If a power cycle does not fix this,
return to the factory for recalibration.
02
The checksum is not valid for this area
or the calibration date for this area is
not set.
If a power cycle does not fix this,
return to the factory for recalibration.
03
The identity voltage read does not
correspond to a known configuration.
If a power cycle does not fix this,
return to the factory for repair.
04
There was an error re-writing the
temperature calibration trigger pattern
when starting the temperature cal
cycle.
If a power cycle does not fix this,
return to the factory for repair.
05
An error occurred while writing values
during the temperature calibration
cycle.
If a power cycle does not fix this,
return to the factory for repair.
06
The temperature calibration cycle has
completed, but CalibrATE has not yet
read and checked the results.
If a power cycle does not fix this,
return to the factory for repair.
07
A problem occurred during a hot sync
from an MCA back into a meter.
Try the sync process again.
