Seeker D User’s Guide
Document Num., Rev. 4
May 2018
Page 43
Enable/Disable Peak Hold
To enable/disable the Peak Hold function, turn your Seeker D on and press the
SELECT
button repeatedly until the arrow appears under the PK
icon
,
as indicated by the red circle
in the image below.
• When the Peak Hold display is selected, pressing the
CHANGE
button
will enable/
disable the Peak Hold function.
• When this display is selected, the following will occur:
• If the Peak Hold function is currently disabled, the
PK icon will flash with the arrow below the icon as
indicated by the red circle in the image to the right.
Peak Hold Disabled
Peak Hold Enabled
• If the Peak Hold function is currently enabled, only
the arrow below the PK icon will flash as indicated by
the red circle in the image to the right.
After a few seconds in the Peak Hold display without any
action by the user, the display will revert to the Signal Level
display.
