EASy IP EAS Network Receiver - Operation Manual
19
6.
Network Receiver
Management Program
!
6
Note:
Check with your network or systems administrator if you’re not
sure about your current login account permissions.
2. Insert the software CD in the appropriate drive, if using a CD to install.
3. If you have Autorun enabled for the CD-ROM drive, the software setup program will start
automatically. Otherwise, select the
Start
button then select
Run
, and type
[
drive
]:\Setup.exe, then select the
OK
button. (Substitute the appropriate drive path in the
command.)
Overview
Configuration of the EAS Network Receiver can be performed by using the EAS Network
Receiver Management Program as shown in this chapter or through an Internet Web browser. For
more information on how to configure your EAS Network Receiver through an Internet Web
browser, see
Chapter 7: Web Browser Configuration
.
How to Install the Software
To install the EAS Network Receiver Management Program, perform the following steps:
1. Depending on the operating system you are installing the program on, you may need to log
on as the local administrator.
Note:
If you have a previous version of the EAS Network Receiver
Management Program installed on your system, you will be prompted to
un-install the software before proceeding with the installation of the new
software. For more information, see the How to Un-Install the Software
Section of this chapter.
