© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE‐TG82ES
41
The results will be displayed in the
Cable Diagnostic Table
below.
Test Results:
Displays the diagnostic results for each pair in the cable. One of
the following cable status parameters is displayed:
o
OK:
There is no problem detected with the cable.
o
Open in Cable:
There is an open wire within the cable.
o
Short in Cable:
Two wires are shorted together within the cable.
o
Cross talk in Cable:
There is crosstalk detected between one pair of
wires and another pair within the cable.
Cable Fault Distance:
This parameter specifies the distance from the switch
port to the cable fault.
Reboot/Reset to factory defaults
Tools > Reboot
This section provides the procedures for rebooting or resetting the switch to factory
default settings.
To reboot your switch:
You may want to reboot your switch if you are encountering difficulties with your switch
and have attempted all other troubleshooting.
Note:
You may want to save the settings to flash before reboot the switch under Save
Settings to Flash (menu) > Save Settings to Flash (button). If you have not saved your
current configuration settings to flash first, the configuration changes will be lost after a
reboot.
There are two methods that can be used to reboot your switch.
Hardware Method:
Using a paper clip, on the front panel of the switch, push
and hold the
Reset
button between 1~5 seconds and release.
Software Method (Switch Management Page):
1. Log into your switch management page (see “
Access your switch management page
”
on page 6).
2. Click on
Tools
and click on
Reboot.
3. Click the
Reboot Type
drop‐down list and select
Normal
and click
Apply
to initiate a
reboot. Wait for the switch complete the rebooting process.
