© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE‐TG82ES
16
o
Ignore
‐ This parameter indicates that the
All
setting does not apply to
the
Flow Control
field. In other words, each port is set individually.
o
Enabled
‐ This parameter indicates that the port is permitted to use
flow control.
o
Disabled
‐ This parameter indicates that the port is not permitted to
use flow control.
5. In the left hand panel, click on
Save
6. Click
Save Settings to Flash
, then click
OK.
Note:
This step saves all configuration changes to the NV‐RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Configure Spanning Tree (STP, RSTP)
Network > Spanning Tree > Protocol
Spanning Tree Protocol (STP) provides network topology for any arrangement of
bridges/switches. STP also provides a single path between end stations on a network,
eliminating loops. Loops occur when alternate routes exist between hosts. Loops in an
extended network can cause bridges to forward traffic indefinitely, resulting in
increased traffic and reducing network efficiency.
1. Log into your switch management page (see “
Access your switch management page
”
on page 6).
2. Click on
Network
, click on
Spanning Tree,
and click on
Protocol
.
3. Review the settings. Click
Apply
to save changes.
Spanning Tree State:
Select the STP state on the device. The possible field
values are:
o
Disable
– Disables STP on the device. This is the default value.
o
Enable
– Enables STP on the device.
Spanning Tree Mode:
Specifies the Spanning Tree Protocol (STP) mode to
enable on the switch. The possible field values are:
o
STP
– Enables STP 802.1d on the device.
o
RSTP
– Enables Rapid STP 802.1w on the device. This is the default
value.
STP New Root Traps:
Select the STP Root Trap on the device. The possible field
values are:
o
Disable
– Disables STP Root Trap on the device. This is the default
value.
o
Enable
– Enables STP Root Trap on the device.
STP Topology Change:
Select the STP Topology Change on the device. The
possible field values are:
o
Disable
– Disables STP Topology Change on the device. This is the
default value.
o
Enable
– Enables STP Topology Change on the device.
