© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE‐TG82ES
27
Configure VLAN Port Settings
Network > VLAN > Port
In this section, you can modify the port VID settings, acceptable frame types, and
ingress filtering. In order to modify these settings, you must first add VLANs before set
up (see “
Add, modify, and remove VLANs
” on page 32).
1. Log into your switch management page (see “
Access your switch management page
”
on page 6).
2. Click on
Network
, click on
VLAN,
and click on
Port
.
3. Review the settings for each port. Click
Apply
to save settings.
PVID –
Enter the port VLAN ID.
Note:
Required for untagged VLAN ports.
4. In the left hand panel, click on
Save
5. Click
Save Settings to Flash
, then click
OK
Note:
This step saves all configuration changes to the NV‐RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Configure the VLAN forwarding Table
Network > VLAN > Forwarding
This section allows you to configure your switch to standard 802.1Q VLAN mode (IVL) or
Asymmetric VLAN mode (SVL). Asymmetric VLAN allows the configuration of
overlapping untagged VLAN ports in order to create VLAN groups. It is recommended to
use the standard 802.1Q VLAN mode when possible.
IVL – Independent VLAN Learning
SVL – Shared VLAN Learning (also known as asymmetric VLAN)
Please note the following when switching between forwarding table modes:
FDB (Forwarding Database) will be cleared.
Static Unicast Address entries will be cleared.
Static Multicast Address entries will be cleared.
802.1X authenticated records will be cleared.
IGMP Snooping multicast group addresses will be cleared
When using SVL mode, Voice VLAN will not be supported.
When using SVL mode, the VID field on 802.1Q‐VLAN mode will be displayed as
"N/A".
1. Log into your switch management page (see “
Access your switch management page
”
on page 6).
2. Click on
Network
, click on
VLAN,
and click on
Forwarding
.
3. Click the learning mode drop‐down list to select the forwarding table mode and click
Apply
to save settings.
Note
: The default mode is IVL.
4. In the left hand panel, click on
Save
5. Click
Save Settings to Flash
, then click
OK
Note:
This step saves all configuration changes to the NV‐RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
