TRENDnet TPE-TG82ES, User Manual

Page: 27 / 59

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE‐TG82ES
24
Configure Storm Control
Network > Bandwidth Control > Storm Control
This section allows you to configure the storm control threshold.
1. Log into your switch management page (see “ Access your switch management page ”
on page 6).
2. Click on Network , click on Bandwidth Control, and click on Storm Control .
3. Review the settings for each port. Click Apply to save the settings.

Storm Control Status – Click the drop‐down list and select Enabled to enable
Storm Control.

Storm Control – Select from the type of Unicast traffic to allow: Multicast &
Broadcast & Unknown Unicast, Multicast & Broadcast, and Broadcast only.

Threshold – Enter the kbit/s (kilobits per second) threshold.
4. In the left hand panel, click on Save
5. Click Save Settings to Flash , then click OK
Note: This step saves all configuration changes to the NV‐RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Set Ingress Rate Limiting
Network > Bandwidth Control > Ingress Rate Limiting
This section allows you to set the ingress (receive) rate for each switch port.
1. Log into your switch management page (see “ Access your switch management page ”
on page 6).
2. Click on Network , click on Bandwidth Control, and click on Ingress Rate Limiting .
3. Review the settings for each port. Click Apply to save the settings.

Bandwidth – Select the ingress rate limit value from the drop down menu.
Note: Modifying settings in the row marked All , will apply the settings to all ports.
4. In the left hand panel, click on Save
5. Click Save Settings to Flash , then click OK
Note: This step saves all configuration changes to the NV‐RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.