© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE‐TG82ES
13
Configure the SNMP Trap Management
System > SNMP > Host Settings
A Host IP address is used to specify a management device that needs to receive SNMP
traps sent by the switch. This IP address is associated with the SNMP Version and a valid
Community Name in the Host table of the switch.
1. Log into your switch management page (see “
Access your switch management page
”
on page 6).
2. Click on
System
, click on
SNMP
, and click on
Host Settings
.
3. Review the settings.
Create Trap Host Table Entry
Use the following procedure to create a trap Host table entry:
Enter the
Host IP Address
for the management device that is to receive the
SNMP traps.
Select the
SNMP Version
, either
v1
or
v2c
, that is configured for the host
management device.
Enter a
Community Name
that you have defined previously in the SNMP
Community table. The
Community Name
must correlate with one of the
communities displayed on the SNMP Community Table page. If you enter a
Community Name
that has not been pre‐defined, the Trap Host entry is
displayed, but agent/manager communication fails.
4. Click
Apply
. The new host is added to the table.
5. In the left hand panel, click on
Save
6. Click
Save Settings to Flash
, then click
OK.
Note:
This step saves all configuration changes to the NV‐RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
