© Copyright 2019 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TL2-FG142
54
Delete
Check to delete the entry. The designated entry will be deleted during
the next save.
MVR VID
Specify the Multicast VLAN ID.
Be Caution: MVR source ports are not recommended to be overlapped
with management VLAN ports.
MVR Name
MVR Name is an optional attribute to indicate the name of the specific
MVR VLAN. Maximum length of the MVR VLAN Name string is 32. MVR
VLAN Name can only contain alphabets or numbers. When the optional
MVR VLAN name is given, it should contain at least one alphabet. MVR
VLAN name can be edited for the existing MVR VLAN entries or it can be
added to the new entries.
IGMP
Address
Define the IPv4 address as source address used in IP header for IGMP
control frames.
When the IGMP address is not set, system uses IPv4 management
address of the IP interface associated with this VLAN.
When the IPv4 management address is not set, system uses the first
available IPv4 management address.
Otherwise, system uses a pre-defined value. By default, this value will be
192.0.2.1.
Mode
Specify the MVR mode of operation. In Dynamic mode, MVR allows
dynamic MVR membership reports on source ports. In Compatible
mode, MVR membership reports are forbidden on source ports. The
default is Dynamic mode.
Tagging
Specify whether the traversed IGMP/MLD control frames will be sent as
Untagged or Tagged with MVR VID. The default is Tagged.
Priority
Specify how the traversed IGMP/MLD control frames will be sent in
prioritized manner. The default Priority is 0.
LLQI
Define the maximum time to wait for IGMP/MLD report memberships
on a receiver port before removing the port from multicast group
membership. The value is in units of tenths of a seconds. The range is
from 0 to 31744. The default LLQI is 5 tenths or one-half second.
Interface
Channel
Profile
When the MVR VLAN is created, select the IPMC Profile as the channel
filtering condition for the specific MVR VLAN. Summary about the
Interface Channel Profiling (of the MVR VLAN) will be shown by clicking
the view button. Profile selected for designated interface channel is not
allowed to have overlapped permit group address.
Profile
Management
Button
You can inspect the rules of the designated profile by using the following
button:
Navigate: List the rules associated with the designated profile.
Port
The logical port for the settings.
Port Role
Configure an MVR port of the designated MVR VLAN as one of the
following roles.
Inactive: The designated port does not participate MVR operations.
Source: Configure uplink ports that receive and send multicast data as
source ports. Subscribers cannot be directly connected to source ports.
Receiver: Configure a port as a receiver port if it is a subscriber port and
should only receive multicast data. It does not receive data unless it
becomes a member of the multicast group by issuing IGMP/MLD
messages.
Be Caution: MVR source ports are not recommended to be overlapped
with management VLAN ports.
Select the port role by clicking the Role symbol to switch the setting.
I indicates Inactive; S indicates Source; R indicates Receiver
The default Role is Inactive.
Immediate
Leave
Enable the fast leave on the port.
Button
Click to add new MVR VLAN. Specify the VID and configure the new
entry. Click "Save".
Click to save changes.
Click to undo any changes made locally and revert to previously saved values.
Summary of Contents for TL2-FG142
Page 1: ...TRENDnet User s Guide Cover Page...
Page 134: ......
