TRENDnet TEG-3102WS, User Manual

Page: 48 / 95

© Copyright 2022 TRENDnet. All Rights Reserved.
43
TRENDnet User’s Guide
Multi-Gig Web Smart Switch Series
•
Priority: Indicates the port priority. If two paths have the same port cost, the
bridges must select a preferred path. In some instances this can involve the use
of the port priority parameter which is used as a tie breaker when two paths
have the same cost. The range for port priority is 0 to 240. As with bridge
priority, this range is broken into increments, in this case multiples of 16. To
select a port priority for a port, you enter the desired value. Table 1 lists the
values that are valid.
•
Path Cost: This defines a metric that indicates the relative cost of forwarding
packets to the specified port list. Port cost can be set automatically or as a
metric value. Define a value between 1 and 200000000 to determine the
external cost. The lower the number, the greater the probability the port will
be chosen to forward packets. The default port cost: 100Mbps port = 200000.
Gigabit port = 20000.
•
Edge Port Conf/Oper: Indicates if a port is connected to an edge device in the
network topology or not. Select Yes designates the port is an edge port, and No
to designate the port is not an edge port.
•
P2P MAC Conf/Oper: P2P ports are similar to edge ports, however, they are
restricted in that a P2P port must operate in full-duplex. Auto allows the port
to have P2P status whenever possible and operate as if the P2P status were
true. Selecting
Yes indicates a P2P shared link is available. Selecting No means
the port cannot maintain a P2P link.
•
Migration: Enabled indicates the port is configured to accept RSTP and
Disabled indicates the port is not configured to accept RSTP.
•
Status: Select Enabled to enable the status to be shown or Disabled to disable
this feature.
CIST Port Settings
Network > Spanning Tree > CIST Port Settings
1. Log into your switch management page (see “ Access your switch management page ”
on page 5).
2. Click on Network , click on Spanning Tree, click on Global Settings, and click on STP .
3. Select MSTP from the drop down menu on Force Version
4. Click on Cist Port Settings and select the port(s) to configure and click Edit .
5. Review the settings and click Apply to save your changes.