TRENDnet TEG-3102WS, User Manual

Page: 44 / 95

© Copyright 2022 TRENDnet. All Rights Reserved.
39
TRENDnet User’s Guide
Multi-Gig Web Smart Switch Series
Untagged VLAN ports are used to connect edge devices (VLAN unaware) such as
computers, laptops, and printers to a specified VLAN. It is required to modify the Port
VID settings accordingly for untagged VLAN ports under Bridge > VLAN > Port Settings.
(e.g. If the VID for the VLAN is 2, the PVID should also be set to 2)
Select the untagged VLAN ports to add to the new VLAN.
Select the Forbidden ports to restrict from the new VLAN.
Click Apply to save the new VLAN to the table.
In the list, you can click Edit to modify an entry
Note: The default VLAN VID1 cannot be removed.
4. At the top of the right hand panel, click Apply .
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied
PVID & Ingress Filter
Network > VLAN Settings > PVID & Ingress Filter
In this section, you can modify the port VID settings, acceptable frame types, and
ingress filtering.
1. Log into your switch management page (see “ Access your switch management page ”
on page 5).
2. Click on Network , click on VLAN Settings, and click on PVID & Ingress Filter .
3. Select the port would like to modify and click Edit to modify an entry.
4. Review the settings for each port. Click Apply to save settings.
•
Port – Displays the selected port
•
PVID – Select the correct VLAN ID. Note: Required for untagged VLAN ports.
•
Ingress Filtering – Click the drop-down list and select Enabled to enable ingress
filtering or Disabled to disable ingress filtering.
•
Acceptable Frame Type – Click the drop-down list and select which type of
frames can be accepted.
o
All – The port can accept all frame types.
o
Tagged – The port can accept tagged frames only. Untagged frames
are discarded.
o
Untagged – The port can accept untagged frames and frames with
tagged priority information only such as 802.1p.
Note: Modifying settings in the row marked All , will apply the settings to all
ports.