TRENDnet TEG-3102WS, User Manual

Page: 29 / 95

© Copyright 2022 TRENDnet. All Rights Reserved.
24
TRENDnet User’s Guide
Multi-Gig Web Smart Switch Series
IPv4 ARP Aging Time
System > System Settings > ARP Settings
This section allows you to set the timeout for the switch’s ARP Table per each
configured VLAN.
1. Log into your switch management page (see “ Access your switch management page ”
on page 5).
2. Click on System , System Settings , and then ARP Settings .
3. Edit the Max Retries and Timeout
4. At the top right of the screen, click Apply .
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
IPv4 Static ARP
System > System Settings > ARP Settings > ARP Table
This section allows you to statically set ARP entries per each configured VLAN.
1. Log into your switch manag ement page (see “ Access your switch management page ”
on page 5).
2. Click on System , System Settings , ARP Settings and then ARP Table .
3. To add a static ARP entry, click Add to fill out the fields and then press Apply . To
delete an entry, press Delete in the lower table.
•
Address : enter the IP address you would like to statically set to the ARP table.
•
MAC Address : enter the MAC address that you would like to assign to the IP
entered above.
•
Interface : Select the VLAN ID to add the ARP entry to
4. At the bottom of the left hand panel, click Apply .
5 . Click the Apply button on the top right of the screen.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.