Encompass 4 Reader System Guide
TransCore Proprietary.
4-46
Required Materials
You need the following materials to install the Encompass 4 Reader on a wall or flat surface. Ensure the
use of high-quality, corrosion-resistant anchor hardware.
•
Anchor hardware suitable for the surface on which you mount the Encompass 4 Reader. Because
the Encompass 4 Reader weighs only 9 1/2-lbs (4.3-kg), 0.25-in (0.6-cm) bolt hardware is adequate
to secure the unit to a wall or ceiling.
•
Four hex nuts 3/8-16 threaded and four lock washers
•
5/32-inch Allen wrench
•
One Encompass 4 wall mount bracket accessory kit (required)
Procedures
To mount the Encompass 4 Reader to a wall or ceiling
1. Unpack the Encompass 4 Reader. Set aside the pole mount bracket.
Use the bracket in the remaining steps to provide greater adjustment for the Encompass 4 Reader. The
pole-mount bracket is wrapped separately from the Encompass 4 Reader and contains a plastic bag of
four Allen screws and washers.
2. Using the 5/32-inch Allen wrench, remove the factory-mounted bracket attached to the back of the
Encompass 4 Reader. Remove all four Allen screws and lock washers from the bracket and set aside.
3. Unpack the wall-mount bracket accessory kit.
4. Using the Allen screws and lock washers set aside in Step 2, attach the wall-mount bracket to the back
of the Encompass 4 Reader, as shown in
. Tighten the screws to secure the bracket.
Figure 36 Wall Mount Bracket Attached to the Encompass 4 Reader
Summary of Contents for encompass 4
Page 207: ......
