TransCore encompass 4, Manual

Page: 43 / 208

Removing the Tag
To remove a tag mounted with Dual Lock or hook-and-loop, grip the tag at the top and bottom sides.
Gently lift the tag away from the windshield on one end until the tag is free from the windshield.
To remove a tag mounted with suction cups, slide a finger under the tab on the suction cup to loosen it
from the windshield surface.
To remove a tag mounted with double-sided tape, lift the tag away from the windshield working from one
end to the other until the tag comes free. Clean any adhesive residue remaining on the windshield using
isopropyl alcohol. The tape strips cannot be reused.
Installing eGo Plus Exterior-Mounted Tags
This section describes general installation guidelines for TransCore’s eGo Plus Exterior-Mounted tags.
Contact TransCore sales for installation instructions for specific tags.
TransCore’s eGo Plus exterior-mounted tags are constucted from highly durable molded plastic. Designed
for outdoor environments, these rugged tags are water and weather resistant. Beam-powered tags do not
use batteries and require little to no maintenance after installation.
Tags should be mounted with the long edge oriented horizontally (
Figure 16 ).
eGo Plus License Plate Tag
The eGo Plus License Plate Tag (LPT) should be installed on the front of your vehicle on a flat surface.
The LPT is typically screw-mounted in the area of the front bumper where the license plate is located. If
the license plate area of your vehicle is not perpendicular to the ground or is partially obstructed by an
overhanging bumper, you will need to mount the tag at an alternate location in the vicinity of the license
plate.
Note: If your vehicle does not have a front license plate area or if you need to mount the LPT in an
alternate location, contact your tag agency for further options.
Figure 16 Correct Tag Orientation for an Exterior-Mounted Tag
Encompass 4 Reader System Guide
TransCore Proprietary.
3–26