Required supplies
•
eGo Plus License Plate Tag
•
Screwdriver (flat-blade or Phillips depending on your vehicle’s license plate mounting screws)
•
Optional TransCore Exterior Tag Accessory Kit (19077-01). This kit contains tamper-resistant
mounting screws and wrench.
Mounting the LPT to the Vehicle
1. Remove the screws from the license plate area of your front bumper. If your vehicle does not have
mounting screws you will need two self-tapping threaded screws. You can also contact the tag agency
to inquire about the optional TransCore Exterior Tag Accessory Kit.
2. Position the LPT so that it is within 18 inches (46 cm) of the center of the front bumper as shown by the
. If your vehicle’s license plate mounting area is more than 18 inches (46 cm)
from the center, you may need to select an alternate location to mount the tag. Contact your tag
agency if your vehicle requires an alternate mounting location for the LPT.
3. Hold the LPT so that the etched lettering is facing you, the mounting holes are to the top, and the
TransCore logos are at the bottom as shown in
.
Figure 17 Mounting Locations for the LPT
Figure 18 Correct Tag Orientation
Chapter 3 Choosing, Installing, Removing Tags
TransCore Proprietary
3–27
Summary of Contents for encompass 4
Page 207: ......
