Encompass 4 Reader System Guide
TransCore Proprietary.
3–24
Removing the windshield sticker tag
Note:
Once you remove the windshield sticker tag, you cannot reuse it.
If you need to remove the tag from your windshield, peel off the tag starting at one corner, then clean any
adhesive residue remaining on the windshield using isopropyl alcohol. Discard the used tag.
Hard Case Tag General Installation Instructions
TransCore’s eGo Plus hard case tags are designed for mounting to a vehicle’s interior windshield surface.
They are constructed of highly durable, impact-resistant, molded plastic. Customers may choose among
four different mounting options: 3M™ Dual Lock™, hook-and-loop, double-sided tape strips, or suction cups.
Required Supplies
•
eGo Plus Hard Case Tag
•
Commercial glass cleaner and paper towels
General Instructions and Guidelines
•
You MUST correctly and permanently install the tag on the windshield before driving to the toll
plaza. Do not attach the tag to your visor or other temporary location.
•
Do not wave the tag or hold it on the inside or outside of your vehicle as you approach the toll
plaza.
•
If your vehicle has a metallized windshield, the tag should be mounted in the section that is not
metallized, usually near the rear-view mirror. Contact the dealership, manufacturer, or review the
vehicle user manual for proper placement.
Choose a location for your tag
Determine the appropriate location for your hard case tag (
). The tag should be mounted on the
interior windshield, approximately 1 inch (2.54 cm) below the rear-view mirror post.
Figure 14 HC Tag Location for Optimal Performance
Summary of Contents for encompass 4
Page 207: ......
