1
INTRODUCTION
The TI-500E SS Digital Indicator is a general purpose, industrial grade weight indicator. One model is
currently available, distinguishable by display type, enclosure type and power supply. Table 1 shows the
TI-500E SS product matrix.
This model can readout up to 50,000 display divisions and can supply enough current for up to 4-350
Ω
load cells. All setup parameters may be entered via the front panel keys, including calibration.
If your Model TI-500E SS Digital Indicator is part of a complete floor scale or has already been installed
for you, you may skip to the operating instructions. Prior to using the indicator, please read this chapter
carefully and completely. Store the manual in a safe and convenient place so it will be available if you
have questions concerning the operation of the scale.
MODEL
DISPLAY
TYPE
ENCLOSURE
TYPE
POWER SOURCE
TI-500E SS
LED
Stainless Steel
100-240 VAC, 50/60 Hz 30W
TABLE 1: TI-500E SS Series Product Matrix
FCC NOTE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This user guide covers software Version 1.5
©Transcell Technology, Inc. 2009-2012. All rights reserved.
The information contained herein is the property of Transcell Technology and is supplied without liability for errors or omissions. No part
may be reproduced or used except as authorized by contract or other written permission. The copyright and the foregoing restriction on
reproduction and use extend to all media in which the information may be embodied.
Contents subject to change without notice.
975 Deerfield Parkway Buffalo Grove, IL 60089
Tel (847) 419-9180 Fax (847) 419-1515
http://www.transcell.com
