![background image](http://html.mh-extra.com/html/trans-tek/1003/1003_instruction-manual_1150603007.webp)
- 7 -
Figure 2
DC-DC TRANSDUCER BOARD SET-UP
These instructions are given to optimize the DC-DC Transducer Board for the transducer output. This is done
by placing a jumper in one of five possible locations on this board.
{Warning: failure to properly locate the
jumper could restrict the usable electrical stroke of the transducer.}
Unless otherwise requested at time of
order, the jumper will be factory installed in Position #1, allowing for the most transducer stroke. Please see
Figure 2 below.
When powered by the available 15 VDC or ±15VDC excitation, determine
the maximum output voltage from the transducer over its nominal working
range (regardless of polarity).
Remove the four screws that secure the front panel to the case and slide the
circuit board(s) out of the case. Based on the maximum output voltage,
determine the proper jumper position using Table 2.
After making the appropriate changes, reassemble board(s) and front panel into case.
DC-DC TRANSDUCER BOARD SPECIFICATIONS
This board provides excitation voltage to the transducer and coarse scaling of the transducer output. Input voltage
choices include 15 VDC or ±15 VDC.
Supply Voltage to Transducer:
Transducer Output Voltage Range:
Temperature Coefficient of Sensitivity:
Temperature Coefficient of Zero:
Analog Output Voltage:
Analog Output Impedance:
Analog Output Noise and Ripple:
Analog Output Frequency Response:
Analog Output Stability:
±15 VDC ±5% at 30 mA maximum
-13.2 to +13.2 VDC
±.006%/°F typical (±.01%/°C)
±2% LSD maximum, over rated operating temperature range adjustable to
5.0 VDC when the transducer output is between 2.9 and 13.2 VDC; polarity
is the same as that of transducer.
2 ohms maximum; output is short circuit protected and can operate into
loads of at least 1000 ohms without distortion.
2 mVrms maximum
375 Hz (-3db point) nominal
.002% Full Stroke after 30 minute warm-up
Table 2
Summary of Contents for 1003
Page 1: ...M009 0009 Rev 8 MODEL 1003 TRANSDUCER INDICATOR INSTRUCTION MANUAL ...
Page 13: ... 13 Table 3 Table 4 Figure 3 RS232C Option Switch Settings and Pin Designations ...
Page 15: ... 15 S1 S2 S3 S4 SWITCH DEFINITIONS Front Panel View ...
Page 23: ... 23 Table 6 Troubleshooting Guide Table 7 Replacement Mating Connector P Ns ...