![background image](http://html.mh-extra.com/html/trans-tek/1003/1003_instruction-manual_1150603003.webp)
- 3 -
• INTRODUCTION •
The Model 1003 Indicator provides complete interface for most AC-AC LVDTs, DCDTs and Trans-Tek
Angular Displacement Transducers (ADT’s). Equipped with the necessary mating connectors and
mounting hardware, this fully programmable instrument consists of a
base unit
with several standard
features, an integral
personality board
for each type of transducer, and any of several available
options.
A label affixed to the top of the case identifies the personality board and options installed in each
indicator.
MODEL 1003 TRANSDUCER INDICATOR
FRONT PANEL FEATURES
Indicator Lights for Cal
Value, Tare Function and
High & Low Set Points
High Resolution
5 Digit LED Readout
Lighted Bar Indicates
Negative Value
STEP/HI/LO SWITCH (S4) – While in
Program, selects display digit (flashing
number). While in Operate, recalls peak
High and Low values from last reset
Pawl Screws
for Mounting
(4 Places)
DOWN/CAL SWITCH (S3) – While in Program,
decreases flashing digit or shifts decimal point right.
While in Operate, scales display to Cal Value.
PROG/OPER SWITCH
(S1) – Places meter in
Program or Operate Mode.
UP/ZERO SWITCH (S2) – While in Program, increases flashing
digit or shifts point left. While in Operate, acts as tare function.
Summary of Contents for 1003
Page 1: ...M009 0009 Rev 8 MODEL 1003 TRANSDUCER INDICATOR INSTRUCTION MANUAL ...
Page 13: ... 13 Table 3 Table 4 Figure 3 RS232C Option Switch Settings and Pin Designations ...
Page 15: ... 15 S1 S2 S3 S4 SWITCH DEFINITIONS Front Panel View ...
Page 23: ... 23 Table 6 Troubleshooting Guide Table 7 Replacement Mating Connector P Ns ...