![background image](http://html.mh-extra.com/html/trans-tek/1003/1003_instruction-manual_1150603021.webp)
- 21 -
BASE UNIT
The base unit is a line-powered DC voltmeter with the following features:
Operates on 115 VRMS, 50/60 Hz power line
±2 VDC analog output
5 digit, high contrast, LED display
Front panel programming
Programmable set points (2 high, 2 low) with front panel status lamps
Programmable hysteresis values
Programmable calibration value with front panel status lamp
Push button tare (zero) with front panel status lamp
Programmable decimal point position
Peak high and low value display
Rear panel lockout switch to disable front panel switches
Splash resistant front panel with membrane switches
Rugged metal case with RFI shielding
PERSONALITY BOARDS
Each meter includes one of four personality boards to interface with a specific type of transducer.
AC-AC LVDT (7 kHz) Board – For AC-AC LVDTs which operate at 7 kHz (Phase Angle <10°)
AC-AC LVDT (7 kHz) Board – For AC-AC LVDTs which operate at 7 kHz (Phase Angle >10°)
AC-AC LVDT (3 kHz) Board – For AC-AC LVDTs which operate at 3 kHz
DC-DC LVDT Board – For DC-DC LVDTs and Trans-Tek ADTs which operate at 15, 30 or ±15VDC.
OPTIONS
The following options are available with each meter:
Relay Option – Provides contact closures at the rear panel connector, synchronized with the front panel
Set Point Status Lamps.
RS232C Option – Provides RS232C serial communications (transmit only) with handshake, transmitting
the display value.
Relay/RS232C Option – Combines the contact closures of the Relay Option and the communications of
the RS232C Option above.
Summary of Contents for 1003
Page 1: ...M009 0009 Rev 8 MODEL 1003 TRANSDUCER INDICATOR INSTRUCTION MANUAL ...
Page 13: ... 13 Table 3 Table 4 Figure 3 RS232C Option Switch Settings and Pin Designations ...
Page 15: ... 15 S1 S2 S3 S4 SWITCH DEFINITIONS Front Panel View ...
Page 23: ... 23 Table 6 Troubleshooting Guide Table 7 Replacement Mating Connector P Ns ...