![background image](http://html.mh-extra.com/html/trans-tek/1003/1003_instruction-manual_1150603020.webp)
- 20 -
PROGRAMMING VALUES
After applying line power to the Model 1003 Indicator, you may begin programming the High/Low Set
Points, Hysteresis Points, Cal Value and Decimal Point using the controls on the front panel.
Press the Prog/Oper Switch to advance through each program step (listed below)
At each step, the display prompt is shown for about 1 second, followed by the actual value in memory
You will be prompted to enter values for each program step:
(All values are held in nonvolatile memory)
While at Decimal Point
Up Switch moves DP left
Down Switch moves DP right
Hint: Displaying the Negative Sign
The negative sign appears while
decrementing the digits from 9-0-1 in the
first LED space to the left.
Which Keys to Use
Up Switch increases flashing digits
Down Switch decreases flashing digit
Step Switch selected the next flashing digit.
SPH1
SPL1
SPH2
SPL2
HH
HL
Cal
DP
Setpoints
Enter value between
-99999 and 99999
Hysteresis Points
Enter value between 00 and 99
Calibration Value
Enter value between 00000 and 99999
Note: a number less than 20000 is recommended
The Decimal Point may be located between any
of the digits or eliminated altogether
Summary of Contents for 1003
Page 1: ...M009 0009 Rev 8 MODEL 1003 TRANSDUCER INDICATOR INSTRUCTION MANUAL ...
Page 13: ... 13 Table 3 Table 4 Figure 3 RS232C Option Switch Settings and Pin Designations ...
Page 15: ... 15 S1 S2 S3 S4 SWITCH DEFINITIONS Front Panel View ...
Page 23: ... 23 Table 6 Troubleshooting Guide Table 7 Replacement Mating Connector P Ns ...