6
RTAF-SVX001A-EN
Model Number Description
Nameplates
The Sintesis outdoor unit nameplates are applied to the
exterior of the Control Panel. A compressor nameplate is
located on each compressor. When the unit arrives,
compare all nameplate data with ordering, submittal, and
shipping information.
Outdoor Unit Nameplate
See
Figure 1
for a typical unit nameplate.The outdoor unit
nameplate provides the following information:
•
Unit model and size description.
•
Unit serial number.
•
Identifies unit electrical requirements.
•
Lists correct operating charges of R-134a and
refrigerant oil (Trane OIL00311).
•
Lists unit test pressures.
•
Identifies installation, operation and maintenance and
service data literature.
•
Lists drawing numbers for unit wiring diagrams.
Model Number Coding System
Model numbers are composed of numbers and letters that
represent features of the equipment. Shown below is a
sample of typical unit model number.
An example of a typical unit model number (M/N) is:
RTAF 130E UA0V XUA2 N21X 1NXN CVSC AXXX XPAX
1XXX X
Each position, or group of positions, in the model number
is used to represent a feature. Unit model number digits
are selected and assigned in accordance with the
definitions as listed in
“Unit Model Number,” p. 7
. For
example, position 08 of the unit model number above
contains the letter “E”. An “E” in this position means that
the unit voltage is 460/60/3.
Compressor Nameplate
The compressor nameplate provides the following
information:
•
Compressor model number. See
“Compressor Model
Number,” p. 8
.
•
Compressor serial number. See
“Compressor Serial
Number,” p. 8
.
•
Compressor electrical characteristics.
•
Utilization range.
•
Recommended refrigerant.
Figure 1.
Typical unit nameplate
