Trane LPC, Install And Operation Instructions

Page: 54 / 110

54 LPC-SVX01C-EN
CAUTION
Avoid Equipment Damage!
Do not allow the operator display to
come in contact with sharp objects.
5. Touch the target using a small, pliable,
blunt object, such as a pencil eraser.
Hold until the beeping stops. A
second calibration screen appears.
6. Again, touch the target with the
object. Hold until the beeping stops.
The Setup menu appears.
7. Press the Home button. The home
screen appears. Adjusting brightness
and contrast.
To adjust the brightness and contrast of
the operator display:
1. On the home screen, press the Setup
button. The Setup menu appears.
2. Press the page down button to go to
Page 2 of 2.
3. Press the Display Setup button. The
Display Setup menu appears.
4. Press the Adjust Brightness and
Contrast button. The Brightness and
Contrast screen appears.
5. To increase the brightness, press the
buttons along the top row, in
sequence, from left to right.
To decrease the brightness, press the
buttons from right to left.
6. To increase the contrast, press the
buttons along the bottom row, in
sequence, from left to right. To
decrease the contrast, press the
buttons from right to left.
7. Press the Home button. The home
screen appears.
Operation
general
information
Setting up, changing, or disabling the
security password
To set up or change a security password
or to disable its use:
Note: If security is enabled, the logon
screen will display whenever you try to
change a value that is security protected.
To log on, type the password using the
numeric type pad. You will remain logged
on while you continue to work. After 20
minutes, the system will log you off.
1. On the home screen, press the Setup
button. The Setup menu appears.
2. Press the page down button to go to
page 2 of 2.
3. Press the Display Setup button. The
Display Setup menu appears.
4. Press the page down button to go to
page 2 of 2.
5. Press the Setup Security Password
button. The Setup Security Password
screen appears.
6. To set up or change the password,
use the number keys to enter 4 to 8
numbers. Press OK. Security is
enabled.
Note: If a password was previously set
up, a Disable Security button appears on
the Setup Security Password screen.
Press the Disable Security button to
disable security.