Chapter 3: Operating the IP Handset
72
IP Handset menus
To set up the display
You can customize the following items in the display:
•
Active backlight can be adjusted from 10 to 100 percent. The backlight is on
for 15 seconds after the last key press.
•
Standby backlight can be adjusted from 0 to 50 percent and cannot be set
higher than the current Active backlight
•
Screensaver, you can select whether the IP Handset should use a screen
saver when it is not used for one minute.
•
Transparency can be selected.
•
Automatic day/night mode can be selected. This automatically gives you
optimum display light conditions, also for operation in low light areas. If
you do not want to use automatic activation, deselect it. You can still start
it manually from the Main Options menu when needed. For further details
see
To set up the display settings, do as follows:
1. From the
Settings
menu, select
Display
.
2. Move to the setting you want to change.
3. For the backlight settings, use the keys
and
to change the percentage.
4. For the remaining settings, select
Edit
to
and select or deselect the item.
Note
Use the down key to scroll down to
Automatic Day/night mode.
Summary of Contents for FleetBroadband
