43
*Must be performed by Shock Manufacturer Service Department or an Authorized Shock Service Center
General Lubrication
Cables
None of the cables require lubrication;
however, it is advisable to lubricate the
ends of the cables periodically with a
good cable lubricant.
Engine Oil and Filter
Change
Change the engine oil and oil filter at the
scheduled intervals. The engine should
always be warm when the oil is changed
so the oil will drain easily and completely.
NOTE: The rear cargo tray must
be removed to access the oil tank
and top of the engine.
1. Park the vehicle on level ground.
2. Loosen the oil level stick. Be careful
not to allow contaminants to enter the
opening.
XX119
3. Loosen the fill plug on top of the
valve cover. Be careful not to allow
contaminants to enter the opening.
XX051
4. Remove the drain plug and crush
washer from the bottom of the oil
tank. Use a funnel to direct the oil
into a drain pan.
Task
After each use
End of each season
Annually
Clean under the
bottom-out bumper
Yes
Yes
Yes
Clean shock absorber
exterior
Yes
Yes
Yes
Check the assembly for
leaks or loose
components
Inspect
Inspect
Inspect
Check the shaft for
damage or rust
Inspect
Inspect
Inspect
Check the seal head for
leaks or loosening
Inspect
Inspect/Replace*
Inspect/Replace*
Check all mounting
hardware for tightness
Inspect
Inspect
Inspect
Check eyelet bushings/
bearings
Inspect
Inspect
Inspect
Check spring and
spring seats
Inspect
Inspect
Inspect
Change oil, piston and
wear band, clean
interior parts, check
nitrogen pressure*
Every 6 months or every year, depending upon usage
