33
Oil Level Stick
There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure.
NOTE: Engine oil level must be
checked at normal operating tem-
perature and on level ground.
1. Start the engine and allow it to warm
up for several minutes. Let idle until
it achieves full operating temperature
(at least one of the radiator fans
cycles on and off) or take vehicle for
a short drive to achieve full operating
temperature.
2. Let the engine idle for at least 10 sec-
onds before shutting off.
3. Although it is possible to access the oil
tank dipstick with the rear cargo tray in
place, it is recommended to remove the
rear cargo tray (see the Rear Cargo
Tray Removal/Install section).
P0630
VIN Not Programmed or Incompatible
P0641
Sensor Reference Voltage #1 Circuit
Low/Open
P0643
Sensor Reference Voltage #1 Circuit
High
P0651
Sensor Reference Voltage #2 Circuit
Low/Open
P0653
Sensor Reference Voltage #2 Circuit
High
P0685
EFI/Main Relay Circuit Open
P0686
EFI/Main Relay Circuit Low/SG
P0687
EFI/Main Relay Circuit High/SP
P0691
Fan-Primary Relay Control Circuit
Low/SG
P0692
Fan-Primary Relay Control Circuit
High/SP
P0693
Fan-Secondary Relay Control Circuit
Low/SG
P0694
Fan-Secondary Relay Control Circuit
High/SP
P1120
Throttle Position Sensor Lower
Position
P1121
Throttle Position Sensor Lower
Adaption
P1122
Throttle Position Sensor Lower Return
P1123
Throttle Position Sensor Adaption
Condition
P1124
Throttle Position Sensor Limp Home
Adaption
P1125
Throttle Position Sensor Upper
Position
P1126
Throttle Position Sensor Upper
Return
P2100
Throttle Actuator Control Motor Circuit
Open
P2102
Throttle Actuator #1 Control Motor
Circuit Low/SG
P2103
Throttle Actuator #1 Control Motor
Circuit High/SP
P2106
Electronic Throttle Control Output Is
Out Of Range
P2107
Electronic Throttle Control Driver
Over-Temperature
P210C Throttle Actuator #2 Control Motor
Circuit Low/SG
P210D Throttle Actuator #2 Control Motor
Circuit High/SP
P2118
Throttle Actuator Control Motor
Range Error
P2119
Throttle Control Actuator Control
Performance Error
P2122
Pedal Position Sensor #1 Circuit
Low/Open/SG
P2123
Pedal Position Sensor #1 Circuit
High/SP
Display
Fault Description
P2127
Pedal Position Sensor #2 Circuit
Low/Open/SG
P2128
Pedal Position Sensor #2 Circuit
High/SP
P2135
Throttle Position Sensor Plausibility
Error
P2138
Pedal Position Sensor Plausibility
Error
P2299
Brake Pedal Position/Accelerator
Pedal Position Incompatible
P2300
Ignition Coil #1 Primary Circuit
Low/SG/Open
P2301
Ignition Coil #1 Primary Circuit High
P2303
Ignition Coil #2 Primary Circuit
Low/Open
P2304
Ignition Coil #2 Primary Circuit High
P2306
Ignition Coil #3 Primary Circuit
Low/Open
P2307
Ignition Coil #3 Primary Circuit High
P2610
ECU Warm Reset
U0100
Lost Communication with ECM
U0155
LCD Gauge to ECM CAN
Communication Lost
FUEL
OFF
Tilt Sensor Activation Code
! WARNING
Use caution when removing oil level
stick. Exhaust components may be
extremely hot.
Display
Fault Description
