32
MOD306
5. Remove the snap ring on the steering column; then
remove the washer (A) and thrust washer (B); then
slide the shift lever off of the steering housing.
MOD307
MOD308
INSTALLING
1. Lightly grease the inner portion of the shift lever;
then slide the shift lever onto the steering housing;
then install the thrust washer (B) and washer (A);
then install the snap ring.
MOD308
MOD307
2. Install the adjuster bracket to the bottom of the steer-
ing housing; then install two the cap screws. Tighten
to 24 in-lb (2.72 N-m).
MOD306
3. Position the shift cable to the shift lever using the
existing cap screw and a new lock nut. Tighten to
6 ft-lb (8.2 N-m).
4. Position the steering adjuster into place; then install
the lower and upper steering adjuster cap screws.
Tighten both to 6 ft-lb (8.2 N-m). Install the steering
wheel. Tighten to 25 ft-lb (34 N-m).
5. Install the lock clip on the steering shaft; then install
the steering wheel cover.
NOTE: If the hole in the steering shaft does not
align with the slots in the castle nut, tighten the nut
slightly until the next slot aligns with the hole.
Summary of Contents for 800SX
