Tracker Off-Road 800SX, Service Manual

Page: 36 / 192

34
MOD297A
INSTALLING
1. Route the cable into position making sure there are
no kinks or sharp bends.
2. Guide the shift cable into the shift cable bracket.
Install the cable end to the shift arm stud and secure
with a new E-clip. Secure the adjuster nut to the
bracket.
MOD298
MOD297A
3. From under the dashboard, guide the shift cable into
the bracket and install as shown; then secure the
cable end to the shift lever using a new locknut.
Tighten to 6 ft-lb (8.2 N-m) Tighten the shift cable
nut to 20 ft-lb (27.2 N-m).
XX382
MOD304
MOD303
4. Fasten the shift cable to the chassis with the previ-
ously noted cable tie locations.
5. Shift the transmission through all positions making
sure the each gear position illuminates the appropri-
ate gears selected and that the Park Indicator illumi-
nates only when fully in Park. Verify transaxle is in
park by attempting to gently push the vehicle; then
verify vehicle moves in low range without grinding
gears. Adjust as necessary. If no adjustment is neces-
sary tighten the adjuster nuts for the shifter cable on
the transaxle to 20 ft-lb (27.2 N-m)
6. Install the mid/upper dashboard upper; then the skid
plate; then the lower steering adjuster cap screw.