45
MOD686
MOD687
2. Remove the hook on the winch cable. Remove the
two cap screws securing the winch fairlead; then
remove the winch fairlead; then remove the four
outer cap screws securing the bumper to the frame;
then remove the bumper from the vehicle.
MOD688
3. Position the bumper into place; then install the four
outer cap screws securing the bumper to the frame;
then position the winch fairlead into place with the
cable through the fairlead; then install the two cap
screws securing the winch fairlead; then install the
hook to the winch cable.
Finger tighten only at this
time.
4. Install the two cap screws, spacers and new lock nuts
per side on the lower portion of the front bumper.
Tighten all fasteners securely.
Rear Bumper (Optional)
REMOVING/INSTALLING
1. Remove the four cap screws and lock nuts; then
remove bumper. Discard lock nuts. Inspect cap
screws and replace if damaged.
MOD684
2. Remove the four cap screws and two lock nuts per
bumper bracket; then remove bumper brackets. Dis-
card lock nuts. Inspect cap screws and replace if
damaged.
MOD685
3. Install the four cap screws and two new lock nuts per
bumper bracket. Finger tighten only at this time.
4. Position the bumper into place; then install the four
cap screws and new lock nuts; then tighten all hard-
ware securely.
Floor
REMOVING
1. Remove the seats, behind-the-seat storage box panel,
side panels, and seat base.
2. Remove the three fasteners securing the splash panel
on each side.
Summary of Contents for 800SX
