17
Metalyser HM5000 Benchtop
Instruction Manual v1.0
www.trace2o.com
Bluetooth Installation
Your HM5000 instrument is able to communicate with a PC through Bluetooth.
Most newer laptops and some desktops will have built-in Bluetooth connectivity;
however, a Bluetooth adapter dongle is supplied with the instrument. Follow the
procedure to correctly establish a connection to the instrument via Bluetooth.
• If use of the Bluetooth dongle is required, insert the Bluetooth
dongle installation CD and follow the on-screen instructions to
correctly install the Bluetooth software and drivers.
• Turn on built-in Bluetooth, or plug the supplied Bluetooth
dongle into an available USB port on your PC.
• Turn on the HM5000 instrument by depressing the green power switch on
the top of the instrument. The green indicator LED should turn on.
• Double-click the Bluetooth icon, found in the system tray.
• Depending on previous use of Bluetooth, the configuration
wizard may load. Follow the on-screen instructions.
• Select ‘Add device’.
• ‘Metalyser 5XX-XX-XXX’ should be displayed in the window, where the X
values correspond to the serial number of your instrument. If it is not, turn
the instrument off, wait five seconds, then turn the instrument on again.
• Select ‘Metalyser 5XX-XX-XXX’ and click ‘Next’.
• ‘Installing device driver software’ may be displayed.
• You may be asked to enter the PIN for the instrument. This is pre-set as 1234.
• ‘Your device is now ready to use’ will be displayed.
• A Bluetooth connection between the Metalyser and
the computer has now been established.
Software Installation
The HM5000 instrument is controlled through theTrace2o Metaware
Benchtop software, which is provided on the HM5000 CD ROM.
• Load the CD ROM into the CD/DVD drive of the computer.
• Browse to the ‘Metaware Benchtop Install’ folder.
• Double click setup.exe
• Follow on-screen instructions.
