26
www.trace2o.com
Metalyser HM5000 Benchtop
Instruction Manual v1.0
Advanced
It is possible to measure the peak heights manually to provide raw current data
which can assist with diagnostics and facilitate more accurate data analysis.
• Calculate Peak: To calculate a peak, first position the cursor over the data-point
you wish to use as the right hand side of the peak then right click the mouse and
click ‘calculate peak’. If a valid point is not found this function will be greyed out.
Move the mouse to the left hand side of the peak and left click the mouse. The
baseline will be drawn in and the peak height shown, reported as a current (μA).
• Abort Peak Calculation: If an error is made during the selection
of data points the calculation can be aborted.
• Remove all peak data: Removes all of the peak data from the graph.
• Remove this peak data: Used to remove result readings from
voltammogram. Move the cursor over the peak result box and
then select this option which will remove the peak data.
