TP-Link TL-WA7110ND, User Manual

Page: 49 / 50

TL-WA7110ND 150Mbps High Power Wireless Access Point User Guide

Note:
Note Dialog
Ensure you select a correct country to comply with local laws. Incorrect settings may cause
interference. Limited to local law of the United States, selecting country code and channel
function was disabled.
 Transmission Power - The available options of transmission power are determined by the
region selected.
 Wireless Security Mode - This option should be chosen according to the AP's
security configuration. It is recommended that the security type is the same as your AP's
security type.
 WPA/WPA2-PSK - Select WPA based on pre-shared passphrase.
 WEP - Select WEP based on none pre-shared passphrase.

No Security - The wireless security function is disabled. The wireless stations will
be able to connect the Device without encryption.
 Auth Type - This option should be chosen if the Security Mode is WEP. It
indicates the authorization type of the Root AP.
 Key Format - This option should be chosen if the Security Mode is WEP. It
indicates the format of the WEP key.
 WEP Index - This option should be chosen if the Security Mode is WEP. It indicates the index
of the WEP key.
 Wireless Password - If the AP your Device is going to connect needs password, you need to
fill the password in this blank.

Note:
The operating distance or range of your wireless connection varies significantly based on the
physical placement of the Device. For best results, place your Device
 Near the center of the area in which your wireless stations will operate.

In an elevated location such as a high shelf.
 Away from the potential sources of interference, such as PCs, microwaves, and cordless
phones.
 With the Antenna in the upright position.
 Away from large metal surfaces.
Failure to follow these guidelines can result in significant performance degradation or inability
to wirelessly connect to the Device.
2. The AP List page will appear shown as Figure 3-38. Find the BSSID (the same as the MAC
address) of the remote AP that you want to repeat, and then click Connect on the right side
of the line.
36