TP-Link TL-WA7110ND, User Manual

Page: 44 / 50

TL-WA7110ND 150Mbps High Power Wireless Access Point User Guide

Enable WDS - The AP client can connect to AP with WDS enabled or disabled. If WDS is
enabled, all traffic from wired networks will be forwarded in the format of WDS frames consist
of four address fields. If WDS is disabled, three address frames are used. If your AP supports
WDS well, please select the option.
 Wireless Name of Remote AP - The SSID of the AP your Device is going to connect to as a
client. You can also use the survey function to select the SSID to join.
 Mac Address of Remote AP: - The Mac Address of the AP your Device is going to connect
to as a client. You can also use the survey function to select the BSSID to join.
 Survey - Click this button, you can search the APs.
 Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the Router can be used. It may be illegal to use the wireless function of
the Router in a region other than one of those specified in this filed. If your country or region is
not listed, please contact your local government agency for assistance.
When you select your local region from the pull-down list, the Note Dialog of TERMS OF USE
will pop up. Select I agree to these terms of use , and click Accept to continue.

Note:
Note Dialog
Ensure you select a correct country to comply with local laws. Incorrect settings may cause
interference. Limited to local law of the United States, selecting country code and channel
function was disabled.
 Transmission Power - The available options of transmission power are determined by the
region selected.
 Channel - This field determines which operating frequency will be used. It is not necessary to
change the wireless channel unless you notice interference problems with another
nearby access point.

Wireless Security Mode - This option should be chosen according to the AP's
security configuration. It is recommended that the security type is the same as your AP's
security type.
 WPA/WPA2-PSK - Select WPA based on pre-shared passphrase.

WEP - Select WEP based on none pre-shared passphrase.
 No Security - The wireless security function is disabled. The wireless stations will
be able to connect the Device without encryption.
 Auth Type - This option should be chosen if the Security Mode is WEP. It
indicates the authorization type of the Root AP.
32