TP-Link TL-WA7110ND, User Manual

Page: 18 / 50

TL-WA7110ND 150Mbps High Power Wireless Access Point User Guide
2.3.4 Multi-SSID
In this mode, AP can support up to 4 SSID.
Figure 2-4 Hardware Installation of the TL-WA7110ND in Multi-SSID mode
1. Connect the MAIN (PoE) port of TL-WA7110N to the POE port of the Power Injector with an
Ethernet cable.
2. Connect the LAN port of the Power Injector to the wired network port with an Ethernet cable.
3. Plug one end of the Power Adapter into the DC jack on the Power Injector, and the other end
in the electrical wall socket.
4. Power on the notebooks and other connected devices (such as the Switch).
2.3.5 Repeater and Universal Repeater
Figure 2-5 Hardware Installation of the TL-WA7110ND in (Universal) Repeater mode
1. Connect the MAIN (PoE) port of TL-WA7110ND to the POE port of the Power Injector with an
Ethernet cable.
2. Plug one end of the Power Adapter into the DC jack on the Power Injector, and the other end
in electrical wall socket.
3. Power on the PC(s) and other connected devices (such as the Router).

Note:
Both Repeater and Universal Repeater modes allow the AP with its own BSS to relay data to a
root AP. The wireless repeater relays signal between its stations and the root AP
for greater wireless range. However, in Repeater mode, the WDS associated is enabled, while
in Universal Repeater mode, the WDS associated is disabled.
2.3.6 Bridge with AP
Two Devices are needed in this mode.
8