Ø
Destination IP: The IP address of the network or PC you want to
access.
Ø
Subnet Mask: The Subnet Mask of the network or PC you want to
access, the default value is 255.255.255.0.
Ø
Gateway: The IP address of the Router or PC that packet is sending
to. The IP address must be on a same subnet with the Router's WAN
or LAN port.
Ø
Enable: Choose this option to make the Static Routing rule active.
5.9 System
There are six submenus under the
System
menu:
Firmware Upgrade
,
Restore Default
,
Reboot
,
Change Password
,
Log
and
Statistic
. Click
one of them, and you can configure the corresponding function. The
detailed explanations for every submenu are provided below.
5.9.1 Firmware Upgrade
Ø
Ignore Ping Packets From WAN: Enable this function, the Router
will not response to the Ping requests from the WAN.
Ø
Prohibit Ping Packets From LAN: After enable this function, no Ping
packet can pass through the Router from the LAN to the WAN.
5.8 Static Routing
There is only a
Static Route Table
submenu under the
Static Routing
menu. Click it, and you can configure the Static Routing function. The
detailed explanations for the configuration of Static Routing are provided
below.
5.8.1 Static Route Table
This page is to configure the static routing information of the R410 Router.
You can set eight rules of Static Routing.
T L- R 4 1 0
Multifunctional Broadband Router User's Guide
T L- R 4 1 0
Multifunctional Broadband Router User's Guide
