VN/UN564:1VN/UN5674
LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
129
squ"swgwg"equ/ocr"
Fguetkrvkqp"
The
squ"swgwg"equ/ocr
command is used to configure the mapping relation
between IEEE 802.1P priority tag/IEEE 802.1Q tag, CoS value and the TC
egress queue. To return to the default configuration, please use
pq"squ"swgwg"
equ/ocr
command. When 802.1P Priority is enabled, the packets with 802.1Q
tag are mapped to different priority levels based on 802.1P priority mode. The
untagged packets are mapped based on port priority mode.
U{pvcz"
squ"swgwg"equ/ocr"
tag
/
cos-id
tc-id
pq"squ"swgwg"equ/ocr
Rctcogvgt"
tag/cos-id
—— The 8 priority levels defined by IEEE 802.1P or the priority level
the packets with tag are mapped to, which ranges from CoS 0 to CoS 7.
tc-id
—— The egress queue the packets with tag are mapped to. It ranges from
0 to 3, which represents TC0, TC1, TC2, TC3 respectively.
Eqoocpf"Oqfg"
Global Configuration Mode
Wugt"Iwkfgnkpgu"
1. By default, the mapping relation between tag/cos and the egress queue is:
0-TC0, 1-TC0, 2-TC1, 3-TC1, 4-TC2, 5-TC2, 6-TC3, 7-TC3
2. Among the priority levels TC0-TC3, the bigger value, the higher
priority.
Gzcorng"
Map CoS 5 to TC 2.:
VN/UN564:*%squ"swgwg"equ/ocr
5 2
"
squ"swgwg"fuer/ocr
"
Fguetkrvkqp"
The
squ"swgwg"fuer/ocr
command is used to configure the mapping relation
between DSCP Priority and the TC egress queue. To return to the default
configuration, please use
pq"squ"swgwg"fuer/ocr
command. DSCP (DiffServ
Code Point) is a new definition to IP ToS field given by IEEE. This field is used to
