VN/UN564:1VN/UN5674
LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
19
uykvejrqtv"oqfg
Fguetkrvkqp"
The
uykvejrqtv" oqfg
command is used to configure the Link Types for the
ports.
U{pvcz"
uykvejrqtv"oqfg
{ access | trunk | general }
Rctcogvgt"
access | trunk | general —— Link Types. There are three Link Types for the
ports.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Specify the Link Type of Fast Ethernet port 3 as “trunk”:
VN/UN564:*%kpvgthceg"hcuvGvjgtpgv"
1/0/3
VN/UN564:*eqphki/kh+%uykvejrqtv"oqfg
trunk
"
uykvejrqtv"ceeguu"xncp
Fguetkrvkqp"
The
uykvejrqtv"ceeguu"xncp
command is used to add the desired Access port
to IEEE 802.1Q VLAN, or to remove a port from the corresponding VLAN.
U{pvcz"
uykvejrqtv"ceeguu"xncp"
vlan-id
"
pq"uykvejrqtv"ceeguu"xncp"
Rctcogvgt"
vlan-id
—— Specify IEEE 802.1Q VLAN ID, ranging from 2 to 4094.
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
