Toyota ESP9000, Service Manual

Page: 89 / 111

3.ADJUSTMENT
3-10. Limit sensor
[Inspection]
(1) Loosen two setting screws (a) remove
the table set. (Fig.1)
(2) Remove four set screws (e) and then
base cover rear L. (Fig 1)
(3) Remove two setting screws (c) and
the then base cover rearL. (Fig.1)
(4) Remove three set screws (b) and then
base cover front L. (Fig.1)
(5) Remover four set screws (d) and then
X cover. (Fig.1)
(6) Turn power on and carry out home
position return.
Note: Press the［SET］key.
(7) Check the distance X from the right
most surface of the detecting plate to
the center of left side X limit sensor
shown in Fig.2.
(8) Move the X-axis drive system to its
forefront position and check the
distance Y from the back most
surface of the detecting plate to the
center of middle side Y limit sensor.
(Fig.2)
Reference: X=65.7±1mm
Y =213.5 ± 1mm (Flat
frame)
Y
’
=133.5 ± 1mm (Cap
frame)
X cover
Motor
cover
(c)
Base c
front L over
(e)
(b)
FIG.1
X-axis
drive
Limit
sensor
Detecting plate (slit)
Slit
Y
Table set
(a)
(d)
Base cover
rear L
-34-