Toyota ESP9000, Service Manual

Page: 109 / 111

FIG.2
4-8. Power circuit board
4. REPLACEMENT OF MAIN COMPONENTS
［Removal］
(1) Remove two setting screws (a) and the
table set. (Fig.1)
(2) Loosen four setting screws (b) and the
rear cover. (Fig.2)
(3) Remove each four set screws (c) and
the base cover rear R. (Fig.1)
(4) Loosen two setting screws (d), remove
other two setting screws (e) and move
the case cover upper. (Fig. 3)
(5) Remove the connector CN9 of the
computer board and all the connectors
of the power circuit board. (Fig.4)
(6) Remove six set screws (f) and remove
the power circuit board (Fig.4)
［Installation］
Attached in the reverse procedure of
removal.
-49-