Toyota ESP9000, Service Manual, Page: 19 / 111

(4) Disconnect the connector, remove two
set screws (g) and Y motor bracket set.
(Fig.3)
(5) Remove four setting screws (h) and the
Y motor. (Fig.4)
［Installation］
(1) Mount the Y motor to its bracket with
four setting screws (h). (Fig.4)
(2) Set the Y motor gear to the belt and
temporarily secure them with two
setting screws (g). (Fig.3)
(3) Adjust the belt tension with setting
screw (e), and then firmly tighten with
two setting screws (g) and nut (f).
(Fig.3)
Note: Check the tension, after tighting
screws (g).
(4) Insert the Y pulley box adjusting
screw (c) into the backmost position
and tighten the nut (d). (Fig.3)
(5) Mount the fan set with two setting
screws (b). (Fig. 2)
(6) Insert the connector.
FIG.1
FIG.2
Base cover
rear R
(a)
Fan set
(b)
Y motor bracket set
(g)
(d) (f)
(c)
(e)
-54-