TouchTunes Barfly TV, Installation And Setup Manual

Page: 76 / 96

64
of a transmitter and a receiver. The transmitter CV-927D-TX is installed near the signal
source, and the receiver CV-927D-RX is placed near the desired display.
Transmitter and Receiver Front and Rear panels
1. RS-232: connect to a RS-232 serial command device.
2. VGA IN: connect to a VGA source device.
3. +5V DC: connect to 5V 4A DC power supply unit.
4. Local VGA: VGA loop-out to a local VGA display.
5. System OUT: plug in a solid STP/UTP CAT-5e/6 cable here to be linked to System IN of
the receiver unit [RX].
6. RS-232: connect to a RS-232 serial command device.
7. VGA OUT: connect to a remote VGA display.
8. +5V DC: connect to 5V DC power supply.
9. System IN: plug in a solid STP/UTP CAT-5e/6 cable here to be linked to System OUT of
the transmitter unit [TX].
10. EQUALIZER: Rotary control for signal equalization, i.e., equalizing the waveform of
VGA signal.
11. GAIN: Rotary control for gain control, i.e., adjusting the amplitude of VGA signal.
12. RGB selector for selecting the respective Red/Green/Blue color channel for de-skew
correction of VGA signal.
13. RGB SKEW ADJUST “–“: Push-in button in step-by-step 2ns decreasing order for
delay control on respective R/G/B color channel that is chosen by the RGB selector.
14. RGB SKEW ADJUST “+“: Push-in button in step-by-step 2ns increasing order for delay
control on respective R/G/B color channel that is chosen by the RGB selector.