4-39
To install the T1900’s FL inverter board, follow the steps below and refer to Figures 4-32 and
4-33.
1.
Connect the
FL inverter cable
and
FL cables
to
CN1
and
CN2
on the FL inverter
board (Figure 4-33).
2.
Seat the
FL inverter board
and route the
cables
so they will not be pinched by the
display cover or other component.
3.
Secure the
FL inverter board
with one
M2.5x6 screw
(Figure 4-33).
4.
Set the
display support plate
in place and secure it with
five M2.5x6 screws
. One
screw also secures the
display ground cable
(Figure 4-32).
5.
Install the display assembly, display mask, top cover, optional PCMCIA card,
optional memory card and battery pack as described in Sections 4.9, 4.8, 4.5, 4.4,
4.3 and 4.2.
Summary of Contents for T1950
