4-31
4.13 T1900C FL Inverter Board
Removing the T1900C FL Inverter Board
To remove the T1900C’s FL inverter board, follow the steps below and refer to Figures 4-26
and 4-27.
1.
Turn off the power to the T1900/T1900C, and, if attached, disconnect the AC
adapter, power cord and all external cables connected to the computer.
2.
Remove the battery pack, optional memory card, optional PCMCIA card, top
cover, and display mask as described in Sections 4.2, 4.3, 4.4, 4.5, and 4.8.
3.
Remove the four
M2.5x6 screws
securing the
display support plate
(Figure 4-26).
Figure 4-26 Removing the Display Support Plate
4.
Remove the
two M2.5x6 screws
securing the
FL inverter board
(Figure 4-27).
5.
Carefully rotate the
FL inverter board
out from right to left and disconnect the
FL
inverter cable
from
CN1
and the
two FL cables
from
CN2
and
CN3
(Figure 4-
27).
Summary of Contents for T1950
