4-14
4.7
Hard Disk Drive • Backup Battery
Removing the Hard Disk Drive • Backup Battery
To remove the T1900/T1900C’s hard disk drive and backup battery, follow the steps below
and refer to Figures 4-9 through 4-12.
1.
Turn off the power to the T1900/T1900C, and, if attached, disconnect the AC
adapter, power cord and all external cables connected to the computer.
2.
Remove the battery pack, optional memory card, optional PCMCIA card, top
cover, and keyboard as described in Sections 4.2 through 4.6.
3.
Remove the tape next to the keyboard connector (PJ4).
4.
Remove the
five M2.5x6 screws
securing the
keyboard base plate
to the bottom
cover and lift off the plate (Figure 4-9).
Figure 4-9 Removing the Keyboard Base Plate
5.
Remove the tape over the
backup battery cable
and lift out the
backup battery
(Figure 4-10).
NOTE:
The connector
(PJ503)
for the backup battery cable is easily accessible
upon removal of the HDD, therefore remove the HDD before attempting to
disconnect the cable.
Summary of Contents for T1950
