– 81 –
<Wireless remote controller>
How to set wireless remote controller as sub remote controller
Turn on the bit 4 of DIP switch SW30 on the signal receiving unit and change P.C. board.
“B
”
Display
“
00
”
Display
TEMPORARY button
DIP switch [SW
3
0]
4
ON=Sub
3
ON=B
OFF=Master
OFF=A
2
Not used
1
Not used
SW
3
0
SW
3
0
1
ON
2
3
4
Wireless remote controller A-B selection
Using 2 wireless remote controllers for the respective air conditioners, when the 2 air conditioners are closely
installed.
Wireless remote controller B setup
1.
Push the START/STOP button to operate the air conditioner. Push it again to stop the air conditioner.
2.
Push [ Temporary] button on the signal receiving unit to operate the air conditioner.
3.
Point the wireless remote controller at the indoor unit.
4.
Push and hold
CHK
button on the wireless remote controller by the tip of the pencil. “ 00 ” will be shown on
the display.
5.
Push the MODE
MODE
button during pushing
CHK
.
“B” will be shown on the display and “ 00 ” will be disappear and the air conditioner will turn OFF. The
wireless remote controller B is memorized.
Note:
• Repeat above step to reset wireless remote controller to be A.
• The wireless remote controllers do not display “A”.
• The factory default of the wireless remote controllers is “A”.
