Toshiba Gigashot GSC-R30, Owner'S Manual

Page: 16 / 267

16
Handling Your Camera and Cradle
Before using the camera, carefully read and observe the “Safety Precautions”
(
p.8) and the notes described below:
Avoid Using or Storing the Camera in the Following Places
• Places subject to humidity, dust, and dirt
• Places subject to direct sunlight
• Places subject to high or low temperature
• Places filled with highly flammable gas
• Places near gasoline, benzene, or paint thinner
• Places subject to strong vibration
• Places subject to smoke or steam
• Places subject to strong magnetic fields (near electric motors, transformers, magnets,
etc.)
• Places contacting chemicals (such as pesticides), rubber or vinyl products for a long
period of time
Avoid Subjecting the Camera to Vibrations or Impacts
If the camera is subjected to strong vibrations, not only will the camera become damaged,
there might also be a loss of hard disk drive data.
Prevent the Hard Disk Camera from Coming into Contact with Sand
If the camera comes into contact with sand, not only will the camera become damaged,
it will also no longer be repairable.
Take special care when using the hard disk camera near seaside, sandy areas or places
where sand dust is likely to occur.
Pay Attention to Condensation
Sudden Changes in temperature, such as when you move the camera or cradle from a
cold location to a warm one, water droplets (condensation) may form on the inside of the
camera or on the lens.
When this occurs, turn the power OFF, and wait an hour before using the camera. If
condensation forms on the SD Memory Card, remove the SD Memory Card, wipe off any
condensation and wait a short time before using it again.