Toshiba e-STUDIO557, Copying Manual

Page: 40 / 180

2 HOW TO MAKE COPIES
38 Bypass Copying
Bypass Copying
When you make copies on OHP film, sticker labels or non-standard size paper, place the copy paper on the
bypass tray. Bypass copying is also recommended for copying on standard size paper which is not set in any
of the drawers.
y If you select the paper size, you can utilize various functions such as the automatic paper selection
(APS) or the automatic magnification selection (AMS). For details, see the following page:
P.170 “Copying Function Combination Matrix”
y If you place the originals on the RADF for bypass copying and do not set the paper size, the originals
will be copied upside down. Be sure to set the paper size when you wish to do bypass copying.
The operating procedure for bypass copying differs depending on the paper size to be used. See the table
below for the operating procedure of each size.
y Bypass copying stops when the paper placed on the bypass tray runs out during copying, even if the
paper of the same size is in any of the drawers. Copying restarts when paper is supplied to the bypass
tray.
y When bypass copying has been completed, the [FUNCTION CLEAR] button on the control panel
blinks. Press this button to switch bypass copying to normal copying using the drawers.
(Even if you do not press the [FUNCTION CLEAR] button, the bypass copying mode will be cleared
when the automatic function clear mode kicks in after a specified period of time.)
Open the bypass tray for bypass copying.
If the paper is large, pull out the paper holder.
Paper size Procedure
Standard size
Other than North
America: A3, A4, B4,
B5
North America: LD, LT,
LG, ST-R P.39 “Copying on A3, A4, B4 and B5 size paper (in equipment
other than for North America) / LD, LT, LG and ST-R size paper (in
equipment for North America)”
Other than the above P.42 “Copying on other than the above standard sizes of paper”
Others (Non-standard sizes) P.44 “Bypass copying on non-standard size paper”