Toshiba e-STUDIO2500c, Service Manual, Page: 228 / 402

e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM May 2006 © TOSHIBA TEC
10 - 40
[Q] Paper dust holder
[R] 1st drawer transport clutch (Low speed) (CLT2)
(7) Remove each 1 screw fixing the both front
and rear holders.
(8) Remove 2 clips, and then move the front and
rear holders and bushings to the inner side.
(9) Move the registration roller (metal) to the rear
side, and then take it off from the front side.
Fig. 10-80
(1) Take off the registration roller (metal).
P.10-38 "[P] Registration roller (Metal)"
(2) Remove 2 screws, and then take off the
paper dust holder.
Fig. 10-81
(1) Open the board case.
P.2-43 "[K] Board case"
(2) Disconnect 1 connector and remove 1 clip to
take off the 1st drawer transport clutch (Low
speed).
Note:
When assembling the clutch, match the pro-
truded portion of the clutch with the position
shown in the figure.
Fig. 10-82
Registration roller (Metal)
Paper dust holder
1st drawer transport clutch (Low speed)