Toshiba e-STUDIO2500c, Service Manual, Page: 101 / 402

4
May 2006 © TOSHIBA TEC e-STUDIO2500c/3500c/3510c GENERAL OPERATION
4 - 7
4.2.4 Bypass feed copying
1) Insert a paper into the bypass tray.
→
Bypass paper sensor (S40) is turned ON.
- “Ready for bypass feeding” is displayed.
→
Carriages move to the home position.
2) Press the [START] button ON
→
“Ready for bypass feeding” changes to “COPYING”.
→
Exposure lamp (EXP) ON
→
Scan motor (M1) ON
→
Carriages-1 and -2 move forward.
→
Drum motor (M10), transfer belt motor (M7), transport motor (M20), developer unit motor (M9),
fuser motor (M17) and exit motor (M18) turned ON
- The drum, transfer belt, fuser unit, developer unit and exit roller are driven.
3) Bypass feeding
→
Fans rotate in high speed.
→
Bypass feed clutch (CLT8) turned ON.
- The bypass pickup roller is lowered.
→
Bypass pickup solenoid (SOL1) turned ON.
- The bypass pickup roller, feed roller and separation roller start to rotate.
→
Aligning operation
→
Paper reaches the registration roller.
→
After a certain period of time, the bypass feed clutch (CLT8) turned OFF.
4) Hereafter, operations (3) through (6) of “4.2.3. Drawer feed copying” are repeated.
4.2.5 Interruption copying
1) Press the [INTERRUPT] button
→
LED “INTERRUPT” is turned ON.
→
Copying operation in progress is temporarily stopped, and the carriages-1 and -2 return to appro-
priate positions.
→
“Job interrupted job 1 saved” is displayed.
→
Automatic density and reproduction ratio 100% are set. Set number remains the same.
2) Select the desired copy condition
3) After interruption copying is finished:
→
“Press interrupt to resume job 1” is displayed.
→
LED “INTERRUPT” is turned OFF by pressing the [INTERRUPT] button, and the equipment
returns to the status before the interruption.
→
“Ready to resume job 1” is displayed.
4) Press the [START] button
The copying operation before the interruption is resumed.